AVL DynoExactThe DynoExact APA Series, with well over 800 dyno installations worldwide, is AVL’s ultimate answer to the engineer’s needs in research and development of powertrain systems.
Applications- R&D, quality and endurance
- Accurate simulation in the test bed of vehicle load conditions, including wheel slip.
- These dynos are suitable for F1 dynamic engine test cells
- High accuracy with highly dynamic control of the UUT – the cradled design and the highly accurate torque measuring systems enable reproducible results for today’s tight demands.
- The use of these dynos in extreme ambient and environmental conditions is possible thanks to the rigid industrial design
![]() |
- Our dynos cover an extensive range of customer applications
- For steady-state and transient testing as well as for high dynamic tests
- Higher and easily contollable measuring accuracy
- Fast and accurate execution of dynamic speed and torue sets
- Cradled mounted AC machine: good damping of torque pulses and possibility of calibration check without disconnecting the engine
- The cradled mounted design is optimized to offer the highest accuracy during the complete machine lifetime
- Possibility of tourque repeatability check during operation
- Extremely short installation time because of pre-commissioned components
- Excellent dynamics: high torque, small inertia
|
- High measurement accuracy (up to ± 0,1 % FS)
- Torque rising < 3 ms
- Optional simulation of mass zero and of drivetrain oscillation (7bis10Hz)
- Power factor cosφ = 1
- Degree of protection IP 23
- Forced Air cooling
- 25 % Overload (1min in 15 min)
- Bearing temperature monitoring
- Winding temperature monitoring
- Grease lubricated bearings
- Regreasing possibility with nippels
- Bending Beam HBM Z6
|
|
|
|
|
|