/ 183 PORTABLE MEASURING SYSTEM FOR GASEOUS EMISSIONS AVL M.O.V.E GAS PEMS iS The AVL M.O.V.E GAS PEMS iS is a compact, lightweight and easy-to-install Portable Emission Measurement System (PEMS) for measuring the NO/NO2 and CO/CO2 exhaust gas emissions of diesel and gasoline vehicles. It is especially optimized for the Passenger Car “Real Driving Emissions” (RDE) application where low power consumption, compact dimensions, low weight and safe operation are extremely important. The new solution is based on the proven GAS PEMS and, therefore, provides the same high measurement accuracy. MEASUREMENT PRINCIPLE The system can flexibly be installed inside and outside the vehicle on a standard trailer hook mounting system to avoid any exhaust making its way into the vehicle, so protecting the test driver. The system is rain proof and additionally protected by a cover. The protective cover is designed to also optimize the wind drag coefficient to avoid influence to the test vehicle performance. The power distribution, including the batteries, can be mounted on top of the measuring module and are protected by the cover. With an optional trailer hook the GAS PEMS iS system does not need any modification to the test vehicle. The GAS PEMS iS system can be preinstalled on the carrier, warmed up and is ready to use. Then you simply install it on the trailer hook and connect the sample lines to your exhaust system with the quick clamps provided. A ready-to-go installation can be achieved in less than three minutes! Y-Type heated line for dual exhaust pipe configurations AVL GAS PEMS iS installed on a trailer hook mounting system APPLICATION Due to its compact, lightweight and smart design, the AVL M.O.V.E GAS PEMS iS is an efficient solution for the upcoming EU Real Driving Emission (RDE) and Chinese NOx regulations for HD vehicles. It is also an efficient solution for “on-the-road” engine and vehicle development and vehicle surveillance testing. BENEFITS AT A GLANCE • Optimized and complete solution for RDE application • Compact and lightweight • Fast and safe installation • Flexible installation in or outside the car and with or without exhaust flow meter • No additional damping plates needed for passenger car application • Wide operating range from - 30°C to + 45°C • High measurement accuracy • Y-type heated line is available in the case of dual exhaust pipe configurations
Solutionskatalog2016_EN
To see the actual publication please follow the link above