The iGEM device control SW provides full control of the HSS down to valve and sensor level. / 144 SIMULATION SOLUTIONS TEST SYSTEM SOLUTIONS TESTING EQUIPMENT Dynamometers and Actuators Vehicle Testbeds Test Cell Mechanics and Control Room Media Conditioning Consumption Measurement Injection Testing Combustion Measurement Emission Analysis and Measurement In Vehicle Measurement SIMULATION TOOLS TESTING TOOLS CUSTOMER SERVICES HEATED SAMPLING SYSTEMS AVL HSS i60 The HSS product line consists of Pre-Filters, Heated Sample Selection Modules and a Heated Boost Pump for raw exhaust measurements. MEASUREMENT PRINCIPLE Pre-filters remove particulates from the exhaust gas and prevent contamination of sample lines and emission measuring systems. Heated sampling systems offer the possibility to switch an AMA i60 or a SESAM i60 FT to d ifferent sample points or l ines. Sample points are e.g. single cylinders of an engine, while sample l ines are e.g. different testbeds that share one emission measuring system. Sample Selection Modules come with two up to four inlets or up to 10 inlets and one outlet. In addition dual stream modules with up to nine inlets can be chosen. Depending on the specific model, further extensions like additional inlet filters and flame traps, cal ibration gas inlets, backflush functionality, turbo pressure regulators, pressure drop and flow sensors etc. ar e available. The Heated Boost Pump is required to overcome the pressure drop in case of very long heated sample lines. APPLICATION Depending on the engine and fuel type as wel l as the sample point (e.g. pre-cat, post-cat, post- DPF), different filter materials such as ceramic, fiber glass, stainless steel or t itanium can be used. Boost pumps are used in applications with very long distances (> 17 m) from the sampling point to the emission measuring system. Typical applications are test cell-sharing and large test cells as used in marine vessel engine test ing. Furthermore, boost pumps are applied in altitude and altitude simulation testbeds. BENEFITS AT A GLANCE • Extendable with e.g. pressure drop sensor, pressure regulation etc. • Minimized delay time for transient measurements due to innovative valve manifold layout • Optimized design to mini- mize wall effects (hang-up) • Sample point and sample line switching (up to 10 inlets) • Boost pump with controlled recirculation circuit – no bypass required • Stand-Alone pre-filter to be connected to third- party equipment
Solutionskatalog2014_E
To see the actual publication please follow the link above